Item name Description
Include/Exclude Specify whether to include or exclude a specified range in
the network search.
Range Type Select [One Host Name], [One IP Address], [Specify IP
Range], or [IPv6 Address] as a type of the value to be
specified.
Host Name Specify this setting only if [Range Type] is set to [One Host
Name]. Use 1 to 255 characters.
From Enter the discovery target IP address, IPv6 address or start IP
address of the discovery target IP address range.
To Enter the end IP address of the discovery target IP address
range.
Subnet Mask Enter the subnet mask in the IP address range specified by
[From] and [To].
[Access Accounts] tab
Set an account used for access to devices at the time of discovery. Change the account to be used
from [Not Assigned Accounts] to [Assigned Account] by clicking the [
] [ ] button or by dragging
and dropping.
[General] tab
If the [Reverse DNS Lookup] is enabled, the machine attempts to determine the host name of the
device whose address has been detected. If the attempt fails, only the device address appears.
Item name Description
Reverse DNS Lookup Select this to enable the [Reverse DNS Lookup] to determine
device host names.
For an outline of the functions related to these settings and their operation, see page 62 "Searching for
Devices".
Manual Discovery
Specify the search range and search conditions for the device you want to search.
Manual Discovery task is configured on the [Discovery Range (Network Search)], [Access Accounts],
and [General] tabs.
5. Discovery and Polling
54
To Next Page
Loading...
