Ricoh A2 - Specifying Access Profiles; Snmp; Device Administrator

Specifying Access Profiles
To configure access profile information, configure an SNMP account or device administrator account
profile according to page 59 "Configuring Access Accounts", and then select the access profile you
have created for the SNMP account or device administrator account according to page 61 "Specifying
Access Profiles".
SNMP
1. In the section area, click [Discovery & Polling].
2. In the [Add Device] category on the section tree, click [Broadcast] or [Network Search]
tab.
3. Click on the [Access Accounts] tab, and then select the access account you have created or
edited.
4. Click (Save).
Device Administrator
1. In the [Device List] section, click a target group to display the corresponding device list.
2. Select a target device in the list area.
3. Click [Access Accounts] in the [Device Administrator Access] in the properties area.
4. Select a profile from the "Profile Name:" pull-down menu.
5. Click (Save).
• If there are more than one Device Administrator accounts, first select the one that is used on the
largest number of devices as the default settings, and then select the accounts for the other devices
one by one.
Specifying Access Profiles
61