Activating the RC Gate
Connect to the Internet directly from the RC Gate and activate the product.
This function is required to use the counter per user function. When a proxy server is required to access
the Internet, configure the required settings in the [Proxy Server] in the [Networking] in the [Server
Settings] category under the [System] section. For details about proxy server, see page 74
"Networking". When using the DNS server, the activation fails if the settings are not specified correctly.
For details about DNS server settings, see page 68 "Networking".
• If the product is not deactivated before the network interface is replaced, consult your sales or
service representative.
Activating
Connect to the Internet directly from the RC Gate and activate the product.
1. Click the [System] section.
2. Click [Activation] under [System Settings].
3. Click [Activation] button.
4. Enter the product key.
Enter the product key that you purchased.
5. Select the country where the product is used in [Country].
Activation is performed even if this setting is not specified.
6. Enter the organization in [Organization].
Use 0 to 250 characters. Activation is performed even without making this entry.
7. Click [OK].
Deactivating the Product
Make sure to deactivate the RC Gate first, and then uninstall the product. This procedure is required to
re-use the product key again.
• You cannot use the counter per user function after the product has been deactivated.
Connect to the Internet directly from the RC Gate and deactivate the product. When a proxy server is
required to access the Internet, configure the required settings in the [Proxy Server] in the [Networking]
6. System
84
To Next Page
Loading...
Need help?
General
