Troubleshooting
38
4
Following output tray is full.
Remove the paper. Internal
Tray 1.
Internal Tray 1 is full. Remove paper from the tray.
Following output tray is full.
Remove the paper. Internal
Tray 2.
Internal Tray 2 is full. Remove paper from the tray.
HDD has a problem. Call ser-
vice representative.
An error has occurred in the optional Hard Disk Drive.
First turn the power switch off and then on. If the message ap-
pears again, call your sales or service representative.
HDD has not been installed. Install an HDD unit. If this error reappears even if there is an
HDD unit installed, contact your service representative.
HDD is full. Delete unnecessary files stored in the machine. Also, reduce the
size of sample or locked print files.
HDD is full. Delete unnecessary fonts or forms stored in the machine.
Hex Dump Mode The machine is in Hex Dump Mode.Wait for a while, and if the
“Hex Dump Mode” message does not disappear, press {
{{
{Online}
}}
}
on the Display panel to return to the “Ready” condition.
LCT has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
The LCT is malfunctioning. Turn the main power off on the ma-
chine and after 5 seconds turn the power on again. If the same
message appears again, contact your service representative.
Invalid Password Try Again. An invalid password has been entered for a locked print job.
Load following paper in #, or
select another tray and press
[Continue]. To cancel job,
press [Reset].
The specified paper tray is empty. Set paper in the paper tray
or press [Form Feed], specify another paper tray, and then press
[Continue] or [Reset].
Menu Protected Cannot
Change.
The selected menu is protected.
No Files Exist. The sample print or locked print file is not found.
NV-RAM has a problem. Call
service representative.
An error has occurred in the optional Memory Unit.
Turn off the power switch, replace the Memory Unit, and then
turn on the power switch.
Offline The machine is offline.
If you want to put the machine online, press [Online].
Output tray has been
changed.
Set the correct output tray.
Overflow Display list overflow occurred during printing with PCL or PS3.
Expand memory.
Paper in duplex unit. Open
cover and remove paper.
There is a misfeed in the Duplex Unit.
Remove the misfed paper.
Paper in staple tray. Open
finisher cover and remove
paper.
Remove the paper remaining inside the finisher.
Messages/Second messages Descriptions and Solutions
To Next Page
Loading...
