Error & Status Messages on the Display Panel
39
4
Paper size and type are mis-
matched. Select another tray
from the following and press
[Continue]. To cancel the job,
press [Reset]. Paper size and
type can also be changed in
User Tools.
Using the auto tray selection function, a tray of the matching pa-
per size and type is not found. Select another paper tray, change
the paper size by using the paper size dial on the tray or paper
size setting on the menu, and then change the paper type of the
selected tray by using the paper type setting on the menu. Oth-
erwise, press [Form Feed], specify another paper tray, and then
press [Continue] or [Reset].
Paper size and type of # are
mismatched. Select another
tray from followings and
press [Continue]. To cancel
job, press [Reset]. Paper size
and type can also be changed
in User Tools.
The paper size and type of selected paper tray differ from the
specified paper size and type. Change the paper size of the se-
lected tray by using the paper size dial on the tray or paper size
setting on the menu, and then change the paper type of the se-
lected tray by using the paper type setting on the menu. Other-
wise, press [Form Feed], specify another paper tray, and then
press [Continue] or [Reset].
Paper size of # is mis-
matched. Select another tray
from followings and press
[Continue]. To cancel job,
press [Reset]. Paper type can
also be changed in User
Tools.
The paper size of the selected paper tray differs from the speci-
fied paper size. Change the paper size of the selected tray by us-
ing the paper size dial in the tray or the paper size setting on the
menu. Otherwise, press [Form Feed], specify another paper
tray, and then press [Continue] or [Reset].
Paper type of # is mis-
matched. Select another tray
from followings and press
[Continue]. To cancel job,
press [Reset]. Paper type can
also be changed in User
Tools.
The paper type of the selected paper tray differs from the spec-
ified paper type. Change the paper type of the selected tray by
using the paper type setting on the menu. Otherwise, press
[Form Feed], specify another paper tray, and then press [Con-
tinue] or [Reset].
Parallel I/F board has a prob-
lem. Call service representa-
tive.
Parallel I/F board has a problem. Contact your service repre-
sentative.
Please wait. The machine is warming up or setting the toner.
Printer is in use. Try again af-
ter the job is completed.
The system settings menu cannot be displayed because data
processing is in progress.
Printing... Wait for a while.
Print overrun. Try installing an SDRAM module. When doing this, contact
your service representative.
Ready The machine is online and ready to make prints.
If you want to take the machine offline, press [Online].
Reset # correctly, or select an-
other tray and press [Contin-
ue].
The selected paper tray (current tray) is not found. It has not
been set or is set incorrectly. Set the paper tray correctly.
Reset duplex unit correctly. If
the error appears again, call
service representative.
The optional Duplex Unit is not set correctly.
An error has occurred in the Duplex Unit.
Set the optional Duplex Unit correctly. If the message appears
again, call your sales or service representative.
Messages/Second messages Descriptions and Solutions
To Next Page
Loading...
