Troubleshooting
40
4
Resetting job... The print job is being reset.
Wait for a while.
RPCS graphic error. There is the possibility that the SDRAM is not working correct-
ly. For details, contact your service representative.
RPCS Memory Overflow. There is the possibility that the SDRAM module is not working
correctly. For details, contact your service representative.
RPCS memory overflow. Printing canceled by the autojob cancel.
RPCS syntax error. A syntax error occurred. Be sure to use the printer driver
matching the model of your machine.
Shift tray has a problem. Call
service representative.
Malfunction occurs when using the Shift function. Contact your
service representative.
Staple has been cancelled. Check the paper direction, printing direction as well as the post-
process positioning settings.
Staple is almost empty. There are a few staples remaining.
Please load in more staples.
Toner is almost empty. The toner has almost run out.
Prepare a new toner cartridge. If the image density gets too
light, replace the toner cartridge with a new one.
Tray # has a problem. Select
another tray and press [Con-
tinue]. To cancel job, Press
[Reset].
An attempt requiring a service call was made to feed paper from
the tray. Select another tray or cancel printing.
Tray 1 has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
The feed motor for Tray 1 is not functioning properly. Turn the
machine power on and off to check whether the error recurs. If
the error recurs, call your service representative.
Tray 2 has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
The feed motor for Tray 2 is not functioning properly. Turn the
machine power on and off to check whether the error recurs. If
the error recurs, call your service representative.
Tray 3 has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
The feed motor for Tray 3 is not functioning properly. Turn the
machine power on and off to check whether the error recurs. If
the error recurs, call your service representative.
Tray 4 has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
The feed motor for Tray 4 is not functioning properly. Turn the
machine power on and off to check whether the error recurs. If
the error recurs, call your service representative.
Unauthorized user access.
Print job has been cancelled.
Check the User Code permission conditions.
Waiting... The machine is waiting for the next print job.
Wait for a while.
Messages/Second messages Descriptions and Solutions
To Next Page
Loading...
