SERVICE PROGRAM MODE
SM 4-39 B089/B093
Service
Tables
5801 Memory Clear
Resets all correction data for process control and all
software counters, and returns all modes and
adjustments to their default values. (! 4.2.7).
To execute, hold down
for over 3 seconds, and
then turn the copier off and on again.
Use this SP only after replacing the NVRAM, or after
the copier has malfunctioned due to a damaged
NVRAM.
5801 1 All Clear Initializes items 2 ~ 12 below.
5801 2 Engine
Initializes all registration settings for the engine and
processing settings.
5801 3 SCS
System Control Service. Initializes default system
settings, CSS settings, operation display coordinates,
and ROM update information.
SCS: System Control Service
5801 4 IMH Memory Clr
Image Memory Handler. Initializes the registration
setting for the image memory handler.
5801 5 MCS
Memory Control Service. Initializes the automatic
delete time setting for stored documents.
5801 6 Copier application Initializes all copier application settings.
5801 7 Fax application
Initializes the fax reset time, job login ID, all TX/RX
settings, local storage file numbers, and the off-hook
timer.
5801 8 Printer application
Initializes the printer defaults, programs registered,
the printer SP bit switches, and printer CSS counter.
5801 9 Scanner application
Initializes the scanner defaults for the scanner and all
the scanner SP modes.
5801 10
Web Service/Network
Application
Deletes the network file application management files
and thumbnails, and initializes the job login ID.
5801 11 NCS
Network Control Service. Initializes the system
defaults and interface settings (IP addresses also),
Smart Net Monitor for Admin, Web Status Monitor
settings, and the TELNET settings.
5801 12 R-FAX
Initializes the job login ID, SmartNetMonitor for
Admin, job history, and local storage file numbers.
5801 14 Clear DCS Settings
Initializes: SP5845 (All), SP5860 (All), SP5861 (All),
SP5863, registered scanner documents and subjects.
5801 15 Clear UCS Settings Initializes: SP5846 (All), SP5801 15
Printer Free Run 5802
Performs a free run for both the scanner and the printer.
After selecting “1”, press “OK” or the
key twice to start this feature. Press the
(Clear/Stop) key to stop.
[0 = No / 1 = Yes]
Input Check 5803
Displays signals received from sensors and switches.
Press the (Clear Modes) key to exit the program. (! 4.2.4)
To Next Page
Loading...
