Technical Bulletin PAGE: 3/4
Reissued:30-Apr-13
Model: Taurus-C1a/C1b (D074/D075) Date: 14-Mar-12 No.: RD074053c
7. Clean the sensors [A].
Use a vacuum cleaner or an air blower to remove dust.
Wipe the sensor with a wet cotton swab. If a cotton swap is not at hand, wipe the sensor
with a wet cloth. Use water if necessary, but DO NOT use any solvent (ethanol, etc).
IMPORTANT
DO NOT attempt to wipe off the “black prints” on the sensors. These black prints are NOT dust/dirt
but are components of the sensor.
[A]
[B]
To Next Page
Loading...
