Riso A2 - Page 96

Customizing Initial Settings [Custom Setting Mode]
94
Advanced Features (Printer Machine Side)
15 Beep Sound
Specify how an alarm should sound when keys are operated or
errors occur.
• Level 2
A beep sounds at all preset occasions; for example at the time
of key operations and event generation/end.
• Level 1
A beep sounds only at the time of error occurrence, setting
completion and pulling-out enabled.
• Level 0
No beep for any occasions.
Level 2 Level 1 Level 0
16 Reserve Period
Change the time in which the output command for original data
from the personal computer is restricted. This can be done for a
crertain period of time, while the machine is in a non-operating
state (only receiving is enabled).
OFF 15
seconds
30
seconds
60
seconds
20 Print Quantity Restoration Setting
Set the restoration setting for Print Quantity.
Select [ON] when you want to restore the Print Quantity after
printing is finished.
OFF
ON
29 Double Feed Check
Set whether to detect double feed (overlapped paper is fed).
OFF ON
32 Auto Switch to Master-Making
Automatically switches to master-making mode and starts master-
making when there is subsequent data for master-making after
printing is completed.
OFF
ON
33 Paper Ejection Adjustment Registration
When special paper is used or the paper is difficult to eject, an
output adjustment from 1 to 4 can be registered and changed
according to the paper to be used and combining each adjustment
value of separation fan, suction fan, and air blow.
p.98 "Registering Paper Ejection Adjustment"
Paper ejection adjustment registration (1): No: P1 to 4
Separation fan (1): OFF/1
/2/3/4
Suction fan (2): 1/2
/3/4
Air blow (1): OFF/ON
34 Paper Ejection Adjustment
Customize the initial setting of [Paper ejection adjustment]
Standard
(0)
1234
52 Total Quantity Display
The total number of copies printed with the machine is displayed.
This number is displayed by two switching screens; a 3-digit
number preceded by an under bar and a 4-digit number.
Example: For 1,234,567 copies,
_1234567
Execute steps 1 through 3 in “Operation Procedure”. p.96
"Operation Procedure"
The total number of printed copies is shown on the Total
Quantity display.
Item
No.
Changeable Items
Parameter Selection
0 1 2 3 4 5