90 Rockwell Automation Publication 5032-UM001A-EN-P - April 2023
Appendix B Troubleshoot Your IO-Link Device
Status and Fault Information in Module Properties
The Module Properties window in the Studio 5000 Logix Designer application includes a series
of views for the IO-Link device.
Each view includes options to configure the device or monitor the status of the device. The
following are ways to monitor the state of a device for faults:
• Device Status on Module Properties Window
• Module Fault Descriptions on Connection View
• Fault and Status Information on Device Info View
Device Status on Module Properties Window
Figure 14 shows where the status of a device is indicated on the Module Properties window.
Figure 14 - Fault Message in Status Line
To Next Page
Loading...
Need help?
General
