Index
I–3
Publication 1336 IMPACT-6.8 – November, 2002
I
Input Rectifier Snubber Board
Illustration, 5–16
Installation, 5–17
Removal, 5–16
Inputs, Available for L Option, 1–3
Inverter Assembly
Installation, 3–27
Part Identification, 5–3, 6–3
Pulling, 3–23
Inverter Bay
See also Inverter Assembly
Schematic, 7–2
Inverter Snubber Board. See Power
Module Snubber Board
J
Jumper, Definition, P–9
L
L Option Board, 1–3
Control Board Jumpers for, 1–3
Definition, P–9
Illustration, 5–13
Option Codes, P–7
Options, 1–3
Removal, 5–4
L Option Mode
Factory Default, 1–5
Selection. See L Option Mode
Three-Wire Control, Multi-Source,
1–6
Three-Wire Control, Single-Source,
1–5
Two-Wire Control, Single-Source,
1–6
Language Module, Option Codes, P–7
LEM. See Current Transducer (LEM)
Local Programming, 1–7
M
Main Control Board. See Control Board
Manual
Audience, P–1
Objective, P–1
Motor Buses
Illustration, 3–15
Installation, 3–16
Removal, 3–14
MOV, Identification, 6–6
N
Nameplate Location, P–3
No Voltage Check, Illustration, 3–8,
3–9
O
Option
Identification, P–3
L Option Board, 1–3
P
Parameter, Definition, P–9
Part Identification, 5–2, 6–2
Part Replacement Procedures, 5–1
Power Module
Illustration, 4–7, 5–21
Installation, 5–21
Removal, 5–20
Testing, 4–6
Power Module Snubber Board
Illustration, 4–9, 5–18
Installation, 5–19
Removal, 5–18
Power Module Snubber Resistor
Illustration, 5–24
Installation, 5–24
Removal, 5–23
Power Supply
Connections, 5–15
Installation, 5–14
Removal, 5–13
Precautions
Electrostatic Discharge, P–2
Safety, P–1
Precharge Board. See Common Bus
Precharge Board
Precharge Board Mounting Frame
Installation, 3–13
Removal, 3–12
Press, Definition, P–9
Procedures
Bus Capacitor Bank Removal, 3–14
Bus Capacitor Bank Replacement,
5–39
Bus Capacitor Bank Testing, 4–12
To Next Page
Loading...
