Rohde & Schwarz R&S ZVA 8 - Page 735

R&S
®
ZVA/ZVB/ZVT SOURce<Ch>:POWer:CORRection...
1145.1084.12 6.273 E-6
<port_number>
Analyzer port number of generator number, if PORT or GENerator
is the first parameter.
Range [def. unit] 1 to port number of the analyzer/number of external generators [–]
*RST values – (for all parameters)
SCPI, Command
Types
Device-specific, no query
Example:
*RST; SOUR:POW:CORR:COLL:VER 0
Disable the verification sweep to speed up the source calibration
procedure.
SOUR:POW:CORR:OSO:STAT OFF
To improve the accuracy, switch off all other sources during the
calibration sweep.
SOUR:POW:CORR:NRE 2; COLL:AVER:NTOL 0.5
Increase the number of readings and reduce the power tolerance
to improve the accuracy.
SOUR:POW:CORR:ACQ PORT,1
Perform a source power calibration using port 1 as a source port.
SOUR:POW:CORR?
Check whether the calibration is applied (the response is 1).
Change the test setup, connect an external generator no. 1 to the
reference plane.
SOUR:POW:CORR:ACQ GEN,1
Perform a source power calibration the external generator no. 1 as
a source.
SOUR:POW:CORR:GEN?
Check whether the calibration is applied (the response is 1).
SOURce<Ch>:POWer<Pt>:CORRection:COLLect[:ACQuire] ASENsor | BSENsor
Initiates a source power calibration for the source port <pt> using an external power meter no. 1 or 2.
To initiate a source power calibration for arbitrary power meters, use the alternative commands listed in
the program example below.
The command cannot be used unless a power meter is connected via GPIB bus, USB or LAN
interface and configured in the External Power Meters dialog.
<Ch>
Calibrated channel number
<Pt>
Calibrated port number.
ASENsor |
BSENsor
External power meter Pmtr 1
External power meter Pmtr 2
*RST value ASENsor
SCPI, Command
Types
Device-specific, no query