Remote Control Commands
R&S
®
Scope Rider RTH
391User Manual 1326.1578.02 ─ 12
METer<m>:FETCh?
Returns the currently measured value.
Use this command after METer<m>:INITiate.
Suffix:
<m>
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Return values:
<Result> Range: -100E+24 to 100E+24
Increment: 0
*RST: 0
Default unit: V
Example:
METer:INITiate
METer:FETCh?
<-- 999.98564109
Usage: Query only
15.7.5.2 METer:MEASure Commands
Sending a METer:MEASure:<function>? command is the same as sending the
METer:CONFigure:<function> command followed immediately by a READ? com-
mand.
METer:MEASure:CONTinuity?.........................................................................................391
METer:MEASure:DIODe?................................................................................................391
METer:MEASure:FREQuency?........................................................................................391
METer:MEASure:TEMPerature?...................................................................................... 391
METer:MEASure:CAPacitance?.......................................................................................392
METer:MEASure:CURRent:AC?...................................................................................... 392
METer:MEASure:CURRent:DC?...................................................................................... 392
METer:MEASure:RESistance?.........................................................................................392
METer:MEASure:VOLTage:AC?.......................................................................................392
METer:MEASure:VOLTage:DC?.......................................................................................392
METer:MEASure:CONTinuity?
METer:MEASure:DIODe?
METer:MEASure:FREQuency?
METer:MEASure:TEMPerature?
Configures the measurement and returns the result.
Return values:
<Range>
Usage: Query only
Digital Multimeter (R&S RTH1002)
To Next Page
Loading...
