Rohde & Schwarz Scope Rider RTH1004 - Page 469

Remote Control Commands
R&S
®
Scope Rider RTH
469User Manual 1326.1578.02 ─ 12
Example:
TRIG:LIN:TYPE ID
TRIG:LIN:IDEN 001001
TRIG:LIN:ICON EQU
Triggers if the ID of the measured signal is 001001.
TRIGger:LIN:IPERror <ParityError>
Triggers on a parity error if TRIGger:LIN:TYPE is set to ERRC
Parameters:
<ParityError> ON | OFF
*RST: ON
TRIGger:LIN:SYERror
<SyncError>
Triggers on a synchronization error if TRIGger:LIN:TYPE is set to ERRC
Parameters:
<SyncError> ON | OFF
*RST: ON
TRIGger:LIN:TYPE <TriggerType>
Parameters:
<TriggerType> SYNC | WKFR | ERRC | ID | IDDT
SYNC
Triggers on the stop bit of the sync field.
WKFR
Triggers after a wakeup frame.
ERRC
Identifies various errors in the frame. You can select one or
more error types as the trigger condition.
ID
Sets the trigger to a specific identifier or an identifier range.
IDDT
Sets the trigger to a combination of identifier and data condition.
The instrument triggers at the end of the last byte of the speci-
fied data pattern.
*RST:
SYNC
15.11.6.3 LIN Decode Results
The frame suffix <m> selects the frame index for which the result is queried.
The byte suffix <n> selects the byte index for which the result is queried.
Protocol Analysis