Rohde & Schwarz SMB 100a - Page 283

R&S SMB Command Description
1407.0806.32 6.91 E-2
SYSTem:COMMunicate:NETWork:DNS:PREFerred 0.0.0.0 .. ff.ff.ff.ff
The command sets the preferred DNS server address manually. The entry is only activated after
sending command SYST:COMM:NETW:DNS:SET.
Example:
SYST:COMM:NETW:DNS:MODE STAT
' the DNS server address is assigned manually.
SYST:COMM:NETW:DNS:PREF 7.8.9.10
'sets the IP address of the preferred DNS server.
SYST:COMM:NETW:COMM:SET ON
'activates the above settings.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:COMMunicate:NETWork:DNS:SET
The command activates the DNS setting (Commands SYST:COMM:NETW:DNS:..).
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:COMM:NETW:DNS:SET
'activates all changes of the DNS settings.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:COMMunicate:NETWork:GET
The command retrieves the current network settings. They can be queried with the corresponding
commands.
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:COMM:NETW:GET
' retrieves the current network settings.
*RST value Resolution Options SCPI
- - Device-specific
SYSTem:COMMunicate:NETWork:IPADdress 0.0.0.0 .. ff.ff.ff.ff
The command enters the IP address . The entry is only activated after sending command
SYST:COMM:NETW:IPAD:SET.
Example:
SYST:COMM:NETW:IPAD 7.8.9.10
'enters the IP address of the R&S SMB.
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP address settings.
*RST value Resolution Options SCPI
- Device-specific