Rohde & Schwarz SMB 100a - Page 284

Command Description R&S SMB
1407.0806.32 6.92 E-2
SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway 0.0.0.0 .. ff.ff.ff.ff
The command enters the IP address of the default gateway. The entry is only activated after
sending command SYST:COMM:NETW:IPAD:SET.
Example:
SYST:COMM:NETW:GAT 1.2.3.4
'enters the IP address of the default gateway.
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP address settings.
*RST value Resolution Options SCPI
28 - Device-specific
SYSTem:COMMunicate:NETWork:IPADdress:MODE STATic | AUTO
The command selects if the IP address is assigned automatically or manually. The entry is only
activated after sending command SYST:COMM:NETW:IPAD:SET.
Parameters: AUTO
The IP address is assigned automatically. The network used must support
automatic assignment of address (DHCP) in order to use this function.
STATic
The IP address is assigned manually.
P2P
A Peer to Peer connection is used.
Example:
SYST:COMM:NETW:IPAD:MODE AUTO
' the IP address is assigned automatically (DHCP).
SYST:COMM:NETW:IPAD:SET ON
'activates DHCP.
*RST value Resolution Options SCPI
AUTO - Device-specific
SYSTem:COMMunicate:NETWork:IPADdress:SET
The command activates the IP settings (Commands SYST:COMM:NETW:IPAD:..).
The command triggers an event and therefore has no *RST value and no query form.
Example:
SYST:COMM:NETW:IPAD:SET
'activates all changes of the IP adress settings.
*RST value Resolution Options SCPI
- - Device-specific