131
Creating a Sample Set
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
Tone Level (Sample Tone level)
Sets the volume of the sample tone. Use this parameter to adjust the
volume balance between sample tones.
Value:
0–127
Tone Pan (Sample Tone Pan)
Sets the pan for the sample tone. “L64” is far left, “0” is center, and
“63R” is far right.
Value:
L64–0–63R
Level Velocity Sens
Set this when you want the volume of the sample tone to change
depending on the force with which you press the keys. Set this to a
positive (+) value to have the changes in sample tone volume
increase the more forcefully the keys are played; to make the tone
play more softly as you play harder, set this to a negative (-) value.
Value:
-63– +63
Tone Output Level
Specifies the signal level for each tone.
Value:
0–127
Tone Chorus Send Level
Specifies the level of the signal sent to the chorus for each tone.
Value:
0–127
Tone Reverb Send Level
Specifies the level of the signal sent to the reverb for each tone.
Value:
0–127
Tone Output Assign
Specifies how the direct sound of each tone will be output.
Value:
PFX:
Output through patch multi-effects.
DRY:
Output without passing through patch multi-effects.
By pressing the [F5 (PFX)] button you can access the PFX (Patch
Multi-effect) editing screen (p. 157).
For details regarding effect settings, refer to the pages shown
below.
•
“Making Effect Settings”
(p. 151)
•
“Making Patch Multi-Effects Settings (PFX)”
(p. 157)
Adjusting the Volume (Amp)
Output Settings (Output)
Setting Effects for a Sample Set
(PFX)
Fantom-G_r_e.book 131 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
