198
Using the Pads
This pad mode lets you use the pads to register and recall frequently
used screens. For example if you frequently move between the patch
edit screen and effect screen, you can use this function to make the
switch easier.
1.
Press [PAD MODE], and then press pad [9] (BOOKMARK).
1.
Access the screen that you want to register.
2.
Hold down [PAD SETTING], and press the pad to which you
want to register the current screen.
For example if you want to register the current screen to pad [3],
the screen will indicate “Bookmarked to #3.”
3.
Press [EXIT].
The setting will be stored.
* If you fail to press [EXIT], the setting will be lost when you turn off
the power.
1.
Press [PAD SETTING].
The Bookmark screen will
appear.
Pads to which screens have
been registered will lit.
2.
Press a lit pad, and the
screen registered to that
pad will be recalled.
* If you want to delete a
registered screen, hold down
[PAD SETTING] in the screen of step 1, and press the pad whose
registration you want to clear.
You can press [ROLL] (BANK) to switch banks (1–8).
→
p. 189
In the Pad Setting screen, you can press [F2 (Pad Exchg)] to
exchange two pads (Pad Exchange, p. 190).
This pad mode allows you to use the pads to turn external MIDI
transmit channels (1–16) on/off.
1.
Press [PAD MODE], and then press pad [10] (MIDI TX SW).
• Pressing pads [1]–[16] will switch external MIDI transmit
channels 1–16 on/off.
• Each pad will be lit when transmission is on, or dark when it is
off.
By pressing [PAD SETTING] you
can check the current pad status.
If numerous MIDI channels are turned on, a large amount of
MIDI messages will be transmitted, possibly causing notes to be
delayed.
9 BOOKMARK
(Using the Pads to Recall Frequently
Used Screens)
Registering a Screen
Recalling a Screen
10 MIDI TX SW
(Using the Pads to Turn External MIDI
Transmit Channels (1–16) On/Off)
Checking the Pad Status
Fantom-G_r_e.book 198 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
