41
Basic Operation of the Fantom-G
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
To edit a value, you can use either the VALUE dial or [INC] [DEC].
In each of the Fantom-G’s screens, move the highlighted cursor
to the value you want to edit, and then edit the value.
VALUE dial
Turn the VALUE dial toward the right to increase the value, or
toward the left to decrease it. The value will change in larger steps if
you hold down [SHIFT] while turning the VALUE dial.
[INC], [DEC]
Press [INC] to increase a value, or [DEC] to decrease it. To make the
value continue increasing (or decreasing), hold down the button. To
make the value increase rapidly, hold down [INC] and then press
[DEC]. Conversely, to make the value decrease rapidly, hold down
[DEC] and then press [INC].
The value will change in larger steps if you hold down [SHIFT]
while you press [INC] or [DEC].
Using the mouse for input
Drag up/down or left/right on the value or knob. Dragging up or to
the right will increase the value, and dragging down or to the left
will decrease the value.
Using the pad for numeric input
If you press the [NUMERIC] pad button, the pads will operate as
numeric keys.
Each pad will enter the following values
When you’ve entered the value, press [ENTER] to finalize your
input. If you decide to cancel, press [EXIT].
Using the knobs for input
If the display shows small numerals (
, , , ), you
can use knobs 1–4 to edit the corresponding parameters.
Editing a Value
When the cursor is located at a parameter value, pressing
[ENTER] (or right-clicking the USB mouse) will open a window
where you can specify the value. You can easily select a value
by pressing or to select the desired value and then
pressing [ENTER].
Pad
Value entered
1–9
1–9
10 0
11 +
12 -
15 , (comma)
16 BS (backspace)
ROLL Cancel
HOLD Enter
Fantom-G_r_e.book 41 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
