195
Using the Pads
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
Play Mode
Specifies how the phrase will be played.
Value
LOOP1:
The phrase will play repeatedly while you hold
down the pad.
LOOP2:
The phrase will play repeatedly. To stop playback,
press the stop trigger pad, or press the same pad
once again.
ONCE:
The phrase will play only once.
Mute Group
This function prevents phrases of the same mute group from playing
simultaneously. For example in an actual performance, a fill-in will
not be played at the same time as a bridge. To simulate this type of
situation, assign the fill-in and bridge to the same mute group
number. You can specify 31 different mute groups. If you don’t want
to assign a mute group, choose the “OFF” setting.
Value:
OFF, 1–31
Note Number
If the
“Keyboard Mode”
(p. 143) is set to RPS you’ll be able to
specify the keys that will play RPS Sets.
Value:
OFF, 21 (A0)–108 (C8)
Move the cursor to the “Note Number” field and press one of
the Fantom-G’s keys to specify the key that will play the RPS.
Trigger Quantize
Specifies how the phrase will begin playing when you press a pad to
trigger it while the song is playing or being recorded.
Value
REAL:
The phrase will play immediately when you press
the trigger pad.
BEAT:
If you press the trigger pad while the song is playing
or recording, the phrase will begin playing at the
beginning of the next beat.
MEASURE:
If you press the trigger pad while the song is playing
or recording, the phrase will begin playing at the
beginning of the next measure.
The Trigger Quantize parameter is a setting maintained within
each song.
Velocity Sens (Velocity sensitivity)
Turn this “OFF” if you want the phrase to play with the velocities at
which it was recorded.
If you want the velocity of the phrase to vary according to how
strongly you pressed the pad, choose “LOW,” “MID,” or “HIGH.”
Value:
OFF, LOW, MID, HIGH
You can save the pad settings by pressing [F7 (Write)].
Quick Setup
In the Pad Setting screen you can press [F3 (Quick Setup)] to specify
the note numbers for sixteen RPS together. For the procedure, refer
to
“Quick Setup”
(p. 192). The parameters will be as follows.
• Template Set
Starting at the base note, the sixteen notes will be assigned to
the following keys.
Value
All:
White and black keys
White Keys:
White keys
Black Keys:
Black keys
• Base Note
Specify the lowest note. When the cursor is located at Base
Note, you can specify this by pressing a key.
Applying the Play Mode to all
(Play Mode All)
In the Pad Setting screen, when the cursor is at the Play Mode field,
pressing [F4 (PlayMode All)] will change all sixteen RPS to the Play
Mode value of the current cursor location.
Fantom-G_r_e.book 195 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
