242
Editing Songs
This function erases all the sequencer data inside the specified area.
As the erased data is replaced by rests, the original measures will
remain.
For details on the settings, refer to
“Phrase Modify Menu”
(p.
239).
Part Group
Specifies the Part Group.
Ch (MIDI Channel)
Selects the MIDI channel of the data to be erased.
When you want to erase all sequencer data, set this parameter to
“ALL.” To erase sequencer data of one specific MIDI channel only,
select that MIDI channel.
Value:
ALL, Ch1–Ch16
Measure, For (Edit Range)
Specifies the range of measures that are to be erased. If you set “For”
to “ALL,” all measures will be specified.
Status
Selects the type of data to be erased.
Value
ALL
NOTE
Poly Aftertouch
Control Change
Program Change
Channel Aftertouch
Pitch Bend
System Exclusive
Tune Request
Range Min, Range Max
If you have set the Status parameter to “NOTE,” “P.AFT,” “C.C,” or
“PROG,” specify the range. Set “Range Min” to the lowest value of
the range, and “Range Max” to the highest value of the range.
To erase all notes or polyphonic aftertouch data, set “Range
Min” to “C -1” and “Range Max” to “G9.” To erase C4, set
“Range Min” and “Range Max” to “C4.” To erase C3 through
C4, set “Range Min” to “C 3” and “Range Max” to “C4.”
• To erase all controller numbers, set “Range Min” to “0” and
“Range Max” to “127.” To erase all program numbers, set
“Range Min” to “1” and “Range Max” to “128.” To erase
number 4, set “Range Min” and “Range Max” to “4.” To erase
numbers 3 through 14, set “Range Min” to “3” and “Range
Max” to “14.”
Erasing Unwanted Performance
Data (Erase)
Value
Explanation
Internal
Internal (internal sound generator)
EXP1 Expansion board 1
EXP2 Expansion board 2
External External MIDI output
ALL All part group
Fantom-G_r_e.book 242 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
