27
Making Connections
Overview Sound 1 Sound 2 Sound 3 Pad Sampler
Menu/System
AppendixSequencer
* Be careful not to pinch your fingers when setting up the stand.
For Fantom-G6/G7 user
If you want to place the Fantom-G6/G7 on a stand, use the Roland KS-18Z.
Place the instrument on the stand as follows.
fig.02-001.e
WARNING:
Use of stand not according to the instructions above will result in instability causing
possible injury.
For Fantom-G8 user
If you want to place the Fantom-G8 on a stand, use the Roland KS-18Z or KS-G8.
Place the instrument on the stand as follows.
fig.02-001.e
WARNING:
Use of stand not according to the instructions above will result in instability causing
possible injury.
Placing the Fantom-G on a Stand
Adjust the width of the stand so that
the rubber feet of the Fantom-G6/G7
straddle the stand
Top view
Align the front of the
Fantom-G6/G7
with the front of
the stand
KS-18Z
Adjust so that the
height does not
exceed 1 meter
(Adjust the stand
to a level no
higher than the
fourth level from
the bottom)
Adjust the width of the stand so that
the rubber feet of the Fantom-G8
are on the inside of the stand
Place the Fantom-G8 so
that it’s rubber feet are in the
inner side of the stand
Align the back of
the Fantom-G8 with
the back of the stand
KS-G8
KS-18Z
Top view
Top view
Align the screws
of the Fantom-G8
with the front of
the stand
Fantom-G_r_e.book 27 ページ ２００９年７月２日 木曜日 午後２時５５分
To Next Page
Loading...
Need help?
General
