6
FAQ
An Error Message Appears
120
[SHEET TOO SMALL CONTINUE?]
The size of the data is larger than the printing area of the loaded media.
To continue printing without correcting this, press . At this time, the portion extending beyond the
printing area is not printed. To stop printing, stop sending data from the computer, then raise the loading
lever. Make the printing area wider, such as by replacing the media with a larger piece of media then send
the data again.
[SHEET SET ERROR SET AGAIN]
The loading lever was lowered while no media was loaded.
Raise the loading lever, place media at the correct location, then lower the lever again.
P. 21, "Loading Media"
[SHEET TYPE] is set to "OPAQUE," but transparent media was loaded.
Raise the loading lever, set the [SHEET TYPE] menu item to "CLEAR" then reload the media.
P. 88, "Using Transparent Media"
The loaded media is too small.
Press any key to clear the error. Replace with media of usable size.
[DATA ERROR CANCELING...]
Printing was stopped because a problem was found in the data received.
Operation cannot be continued. Check for a problem with the connector cable or the computer, and redo the
operation from the step of loading the media.
[WRONG CARTRIDGE]
An ink cartridge that cannot be used was installed.
Remove the ink cartridge to clear the error. Use the ink cartridge of the specied type.
[CLEANING ERROR]
The machine made an emergency stop because an ink cartridge was removed while light
choke cleaning or ink lling for the rst time in the machine was in progress.
Operation cannot be continued. Switch the sub power o and then back on. Perform [SUPER CLEANING] in
all the colors and then, perform [LIGHT CHOKE CLEANING].
P. 64, "When Problems Such As Dot Drop-Out Are Not Cleared Up"
[CANCELED FOR PUMP PROTECTION]
The machine made an emergency stop because the following state has continued for 10 min-
utes or longer while cleaning (normal, medium, powerful, super, light choke, automatic cleaning
when the sub power is off) or while ink lling for the rst time in the machine was in progress.
Machine is left with an ink cartridge removed
Machine runs out of ink
Operation cannot be continued. Switch o the sub power. Then, contact your authorized Roland DG Corp.
dealer or us.
To Next Page
Loading...
