Roland VersaEXPRESS RF-640 - Adjusting the Print Head Height

2
Basic Operation
Setup of Media
34
3. Adjusting the print head height

Press to select [CHANGE].
Press
to enable the setting.

When the screen on the left appears, open the front cover.

Move the height-adjustment lever to adjust
the print head height.
When moving to the [High] direction, the buzzer
sounds twice, and to the [Low] direction, the buzzer
sounds once.

Close the front cover.
For the individual setting method of this setting item and the description, refer to  P. 87, "Adjusting
Print Head Height to Match Media Thickness".
To cancel the setting
Procedure

Press during the setting.

Press to select [YES].
Press
.
The screen returns to the screen on the left.
By selecting [NO], the screen returns to the screen displayed
when you press
.
QUIT SETTING?
YES [NO]
MENU
MEDIA SETTING
HEAD HGT LOW
[CHANGE] NEXT
HEAD HEIGH T
HIGH
LOW
Height-adjustment lever
Move firmly, until it stops.
High
Low
Normally set to [Low]. For the media that is
wrinkled and comes loose from the platen, set
to [High].