4
Part of
Practice
Fully Utilizing the Correction Function
85
Correcting for Misalignment in Bidirectional Printing More Precisely
When further correction is required, such as when adjustment made using [SIMPLE SETTING] does not enhance
printing, use [DETAIL SETTING] to make corrections.
For information on operations, refer to P. 31, "Performing the Initial Adjustment (Correcting for Misalignment
in Bidirectional Printing More Precisely)".
Alleviating Horizontal Bands and the Like (Feed Correction Function)
Procedure
When the roll media is used, check that no sagging is found on the media.
Press .
Press several times until the screen on the left appears.
Press
.
Press .
A test pattern is printed.
When printing is completed, press , and then .
Press to select a correction value.
Press
to enable the setting.
To decide a Correction Value
Select the value to make the upper/lower rectangular gap and overlap smallest. When wavering between two
numbers, select half value.
Gap present Overlap
= Current correction
value
Smallest gap and overlap
Press to go back to the original screen.
To Next Page
Loading...
