4
Part of
Practice
Fully Utilize the Media Heating System
82
Drying the Trailing Edge of the Printing Area on the Dryer
Procedure
Press .
Press several times until the screen on the left appears.
Press
twice.
Press to select “ENABLE.”
Press
to enable the setting.
Press to go back to the original screen.
Description
"ENABLE" : media feed is performed until the trailing edge of the printing area is positioned on the dryer.
The margin between the print-end position and the next print-start position is set to a value of 100 mil-
limeters when [OPTION DRYER] is "DISABLE" or 250 millimeters when "ENABLE."
When you set the margin bigger than the value above on the software RIP, the software's setting is used.
P. 83, "Using an Optional Dryer"
"DISABLE" : media feed stops simultaneously when printing ends. This means that the trailing edge of the
printing area is not fed to the dryer unless you continue with a subsequent printing operation.
Default Setting
[FEED FOR DRY]: DISABLE
Setting the Drying Time After Printing
Procedure
Press .
Press several times until the screen on the left appears.
Press
.
Press several times until the screen on the left appears.
Press
.
Press to select the interval.
Press
to enable the setting.
Press to go back to the original screen.
To Next Page
Loading...
