Roland XR-640 - Page 59

2
Basic Operation
Setup of Media
57

Check the test pattern condition.

[Cutting position and printing position are aligned]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure 9.
[Cutting position and printing position are not aligned]
Press
to select [YES].
Press
to enable the setting.
The test pattern (P&C2) for setting the correction values is printed
and cut. Go to Procedure

.

When the left gure is displayed, press .

Check the correction values from the test pattern condition.
To check the test pattern (P&C1)
Check to make sure that the printing position and the cutting position are aligned.
CONTINUE ADJ. ?
[YES] DONE
INPUT
ADJ. VALUES
To check the test pattern (P&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and feed direction..
Cutting
position
Printing
position
Cutting position and printing position
are misaligned.
Cutting position and printing position
are aligned.
[FEED] side
Cutting line
Scan direction
Cutting line
For the gure, the correction
value is “-0.3.”
Correction-value scale