Roland XR-640 - Page 61

2
Basic Operation
Setup of Media
59

Check the test pattern condition.

[Cutting position and printing position are aligned]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
10.
[Cutting position and printing position are not aligned]
Press
to select [YES].
Press
to enable the setting.
The test pattern (C&C2) for setting the correction values is printed
and cut.

When the left gure is displayed, press .

Check the correction values from the test pattern condition.
To check the test pattern (C&C1)
Check to make sure that the printing position and the cutting position are aligned.
CONTINUE ADJ. ?
[YES] DONE
INPUT
ADJ. VALUES
To check the test pattern (C&C2)
The point where the cutting line intersects the correction-value scale is the correction value. . Check
the scan direction and feed direction.
Cutting position
Printing position
[Cutting position and printing
position are not aligned]
[Cutting position and printing
position are aligned]
[FEED] side
Cutting line
Scan direction
Cutting line
For the gure, the correction
value is “-0.3.”
Correction-value scale