3. Description of the QABrowser
QABrowser Applications
2012-10/4.3A
77
Barracuda & QABrowser Reference Manual
5. Set the generator according to the set values. Make an exposure.
Measured and calculated values are shown for two seconds before the set values
for the next exposure is shown. Make all exposures in the list. You can always go
back to previous exposures by tapping the arrow symbols . You can at any time
go back and redo a previous exposure.
6. Perform all exposures in the list.
7. You can look at the result graphically for each parameter tested. Highlight a
parameter by tapping it with the pen (not the set value) and then tap Graph or
press the corresponding button. The accuracy limits (dotted lines) in the graph
are defined in the QABrowser Setup, see topic QABrowser Setup/Regulations
.
Data Logging3.5
The QABrowser can log data and save data in files on the handheld computer.
Prepare the data log by first entering some basic information about the measurement.
Open the pull-down menu and select Setup or go to the Start Screen and tap Setup.
From the Setup menu select Log.
84
To Next Page
Loading...