3. Description of the QABrowser
Real-time Display and Waveforms
Barracuda & QABrowser Reference Manual
2012-10/4.3A
64
MPD
Shows specific settings for the MPD detector as well as
the serial number.
You can find information about the different parameters
in Settings - MPD .
MAS-2
Shows specific settings and the serial number for the
detector that is connected to the electrometer module
(EMM). In this case it is a MAS-2 probe.
You can find information about the different parameters
in Settings - Other Detectors .
Default values for the settings are depending on the selected type of measurement
and detector.
Tap Back to return to the real-time display.
3.3.3.1 Settings - Conditions
Here general conditions for the measurements are shown. Different values can be
shown depending on selected measured parameter.
Conditions - TF and Waveform
These are parameters of the X-ray generator which
influence the measurements. The Barracuda can
measure these, or you can set them yourself.
Shows actual total filtration value. Estimate means that a new
estimation will be performed at next exposure and the values will be
displayed on screen.
To Next Page
Loading...
Need help?
General