3. Description of the QABrowser
Indicators and Symbols
Barracuda & QABrowser Reference Manual
2012-10/4.3A
90
This symbol indicates that there are more items not visible in a list. Tap the
symbol or press the up/down buttons to view not visible items.
This symbol is similar to the previous. Tap to move the cursor bar up and
down in the built-in applications (accuracy, linearity, reproducibility, and so
on). Grey arrows indicates that the end has been reached. It may also be
used to step between different "rows" in the Quickbar.
This symbol is also similar to the previous ones. It is used for the built-in
applications (accuracy, linearity, reproducibility, and so on), when multiple
parameters is measured, i.e. "All" etc. Tap left or right to move between the
different reading screens. Grey arrows indicates that the end has been
reached, as indicated by the text in between.
This is an animated symbol. Its "movement" indicates that the log is
enabled and active. Tap it to toggle between pause and active.
This icon on the top left side of the Graffiti area takes you to the Favourites,
see section Favourites .
This icon on the bottom left side of the Graffiti area is the menu icon.
Tapping this symbol brings down the drop-down menu from the top of the
screen.
This icon on the bottom right side of the Graffiti area takes you to the
settings screen, see section Measurement Settings .
This icon is not used by the QABrowser.
Measurement symbols. These are shown in the upper rightmost corner of the real-time
display (RTD) and application screens. These are either attention messages, settings
affecting your measurement readings, or settings you have made. Especially when
using favourites they will give you a quicker overview. A surrounding square indicates
the relative position of the three first, as they may be shown simultaneously.
This symbol indicates that the function Beam Correction is active. The set
beam correction factor can be changed under Settings .
This symbol indicates that the function normalize to distance is active. The
set distances can be changed under Settings .
For mammography. This symbol indicates that a compression paddle is
used in the beam. The doses measured by the MPD detector can then be
compensated to simulate the scatter effect, that an ion chamber shows
when a compression paddle is positioned directly above the detector. The
equivalent thickness and scatter factor can be changed under Settings
.
To Next Page
Loading...