EasyManua.ls Logo

Samsung DVM PLUS III - Page 552

Samsung DVM PLUS III
748 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Control Systems
V-20
1
1
Individual control system
1-3. Wired remote controller
2) MWR-WS00
(4) Additional functions
Menu Detailed description Display
SW 8 OFF : Monitor the compensation value of the temperature
sensor in the wired remote controller
SW 8 ON : Set the compensation value for temperature sensor in
the wired remote controller.
Compensate temperature sensor for wired remote controller:
To compensate and display the measured temperature on the
temperature sensor in the wired remote controller.
(ex : Actually measured temperature 20°,
and compensate 5°
It is displayed as 25° when indoor
temperature is displayed).
SW 8 OFF : Monitor whether indoor unit’s FAN RPM
compensation is used
SW 8 ON : Set indoor unit FAN RPM compensation
Compensation of FAN RPM of the indoor unit:
A function to increase the FAN RPM in the indoor unit
(ex : When compensation is set, RPM is changed from low to
medium.)
0 : Use the default RPM of the indoor unit
(Use the indoor unit PCB switch setting as it is.)
1 : Set indoor unit RPM 1 level Up compensation.
2 : Cancel indoor unit RPM compensation.
SW 8 OFF : Monitor the EEV step for the stopped indoor unit
under the Heating mode.
SW 8 ON : Set the EEV step for the stopped indoor unit under the
Heating mode.
0 : Use the default setting for indoor units
(Use the default setting for indoor unit PCB switch).
1 : Fixed step to 0 or 80.
2 : Fixed step to 80.
SW 8 OFF : Monitor the filter replacement time
SW 8 ON :
Set the filter
replacement
time
Filter replacement time:
Set the indoor unit filter replacement time.
0000 : Use the default setting for indoor units.
(Use the default setting for indoor unit PCB switch.)
1000 : Replacement display after 1000 hours.
2000 : Replacement display after 2000 hours.
Temperature compensation value
(-9~9°)
RPM compensation /
no compensation display
Setting value of the EEV step for the
stopped indoor unit during heating
Filter replacement notice time setting
Service mode menu description
05-1_control systems(002~045) 3/15/08 4:09 Page 20

Table of Contents

Other manuals for Samsung DVM PLUS III

Related product manuals