Notes :
1. After each adjustment step is completed, OSD shows “OK”.
2. EEPROM stores confirmed adjustment value of each adjustment step.
3. After finishing the adjustment, reset the main power source to memorize the adjustment data in EEP-
ROM.
4. Camcorder set is used as a LCD adjust tool.
4-2-3 (a) PREPARATION
1. How to get into the LCD adjustment mode.
Note : When XX XX is shown in service adjustment procedures, this indicates variable values.
4-2-3 LCD Adjustment (NTSC)
1. Connect the power source (battery/DC
cable).
2. Set the mode switch of the camcorder to
“CAMERA MODE” position.
3. Set OSD on state.
4. Press and hold the “TAPE EJECT” button
and “DATE/TIME” button on the cam-
corder at the same time for more than 5
seconds.
Then unit goes into service mode.
STEP1
MONITOR OSD shows “ODF XX XX”. Then
LCD adjustment mode has been activated
successfully and press MODE ‘100’ up button
6times, OSD shows “5F7” and then go back-
word to “5E8”
STEP2
5E8
EPR : XX EVR : XX
Samsung Electronics4-36
Alignment and Adjustment
DATA DOWN
MODE DOWN
MODE UP
DATA UP
MODE ‘100’ UP
CONFIRM
To Next Page
Loading...
