56 S&C Instruction Sheet 461-504
Informational and Settings Screens
Add a Test Operation. Click on the green Add a Test button at the bottom of screen to
add a new Test operation to the end of the test sequence. See Figure 78. Test operations
can only be added sequentially from the top down.
Figure 78. The Add a Test button.
Copy and Paste Feature
The Copy and Paste feature can be used to copy TCC curve settings from one trip
operation to another trip operation. This eliminates the need to re-enter TCC curve
settings multiple times. Each trip operation has its own Copy and Paste buttons.
See Figure 79. Note: The open interval between two adjacent operations is not copied.
Figure 79. The Copy and Paste buttons.
Copy. To copy TCC curve settings to the clipboard, click on the Copy button for the
operation being duplicated (e.g., Initial Trip or Test 1, etc.). The Copy button will not be
active until a curve has been completely dened.
Paste. To paste TCC curve settings from the clipboard, click on the applicable Paste
button. The Paste button will not be active until a Copy button is clicked.
To Next Page
Loading...
