S&C TripSaver II - Configuring Trip Operations

60 S&C Instruction Sheet 461-504
Informational and Settings Screens
Configuring a Trip Operation
When a test is added, a new conguration area for that Test operation will be displayed,
but with only two user-congurable elds available at the beginning—the Emulated
Device drop-down menu and the Open Interval setting between the newly added Trip
operation and the previous Trip operation. See Figure 83. For the Emulated Device
drop-down menu, select one of the following four options (additional user-congurable
elds will be displayed depending on what is selected):
• Microprocessor Recloser
• Fuse Link
• Hydraulic Recloser
• Blank (explained in the “Clearing Settings” section on page 59.)
Figure 83. The selections for an emulated device.
Note: When changing the selection for Emulated Device options at any time when
conguring a Trip operation, all settings entered for that Trip operation will be erased.
However, the Open Interval eld can be edited independently.