S&C Instruction Sheet 461-504 59
Informational and Settings Screens
Clearing Settings
To clear settings, either remove the Trip operation and then reinstate it using the Remove
Last Test and Add a Test buttons, or select the Blank option under the Emulated
Device selection menu for that Trip operation, as shown in Figure 81.
Figure 81. The blank option for clearing the TCC setting.
All existing settings will be erased. See Figure 82. Note: Any unwanted curve must be
removed before applying new settings to a TripSaver II recloser. Leaving a curve added
with completely blank settings will not allow the settings to be applied.
Figure 82. The TCC setting erased.
To Next Page
Loading...
