S&C Instruction Sheet 461-504 81
Informational and Settings Screens
Note: the Up arrow is grayed out when the selected item is already on the top of the
list, and the Down arrow is grayed out when the selected item is already on the bottom
of the list.
The arrows are also grayed out when no item in the Screens to Display list has been
selected. See Figure 115.
Figure 115. The arrows are grayed out when no items are selected.
Clear All. Click on this button to remove all items from the Screens to Display list.
See Figure 115.
The Display Screen mode will be disabled if no screens are added to the Screens to
Display list.
LCD Screen Settings Screen—Default Settings
TripSaver II Service Center Conguration Software launches with a set of default LCD
screen settings that match those programmed into the standard TripSaver II recloser
before it leaves the factory. This is the starting point of the LCD conguration process.
The default LCD screen settings are shown below.
Invert Screen When Dropped-Open: Off
Screen When Dropped-Open: Primary Normal screen
Language: English
“Normal” Screen: Primary Normal screen
“Display” Screen Full Sequence Repeats: 2 times
Each “Display” Screen Duration: 3 seconds
Screens to Display: Primary Normal, Load Current, Last Fault Magnitude, Number
of Open Operations, Remaining Contact Wear in %, LCD Screen Temperature,
Sectionalizing Mode Counts, Software Versions.
To Next Page
Loading...
