S&C Instruction Sheet 461-504 85
Informational and Settings Screens
TCC Curve Summary
The “TCC Curve Summary” section is expanded by default. You can collapse the section
by clicking on the green title row. This screen summarizes the basic information of the
congured TCC curves residing in the connected TripSaver II recloser. See Figure 119.
Figure 119. The TCC Curve Summary area.
The following curve information is extracted from the connected recloser.
• Emulated Device. The type of device the curve is emulating. It displays either
Microprocessor Recloser, Fuse Link, or Hydraulic Recloser. See Figure 120.
Figure 120. The columns for emulated devices, curves, and pick-up characteristics.
• Curve. The specic curve used for each trip operation. It displays either the inverse
segment selected for a microprocessor recloser emulation, the speed selected for a
fuse link emulation, or the inverse segment selected for a hydraulic recloser emulation.
• Pickup Characteristics. The pickup characteristics for each trip operation. It dis-
plays either the minimum trip current for a microprocessor recloser emulation, ampere
rating for a fuse link emulation, or coil rating for a hydraulic recloser emulation.
The Low Cutoff setting is also displayed, if enabled.
To Next Page
Loading...
