S&C TripSaver II - Page 87

S&C Instruction Sheet 461-504 87
Informational and Settings Screens
Unit Congured On. This indicates the time stamp the connected TripSaver II recloser
was last congured on, in the format of MM/DD/YYYY HH:MM:SS.milliseconds.
Note: When a TripSaver II recloser is viewed with service center configuration soft-
ware version 2.0 for the first time, the Unit Configured On field will not be visible. To
display the Unit Configured On field in software v2.0, complete the following steps:
STEP 1. Go to Tools>Options menu and select the Communication tab.
STEP 2. Uncheck the Split Prole Apply Messages check box. Then, click the Apply
button.
STEP 3. Go to the Connection menu and select the Disconnect option.
STEP 4. Reconnect to the TripSaver II recloser following the instructions in the
“Connect to Device” section on page 30.
STEP 5. Make a change to the device conguration. Any change will prompt the device
to initialize the conguration date in the register. Validate the change according
to the directions in the “Validate” section on page 33 and then click on the
Apply button. The Unit Congured On eld should now show the correct
information. See Figure 122.
Figure 122. The Unit Configured On field.
Original Catalog Number. This indicates the catalog number of the connected
TripSaver II recloser when it left the factory.