4 Operation and Configuration
131
S84-ex/S86-ex Operator Manual
PRINTER TYPE
Set the print mode.
• DISPENSER: Peel the liner from the printed label as it is advanced to
the printer’s front. Once the printed label has been removed from the
printer for application, the next label will retract and position itself for
printing. You can specify this option only when you have installed the
dispenser unit.
• CONTINUOUS: Print the specified number of media. The media
remains in position for printing at all times.
• LINERLESS: Cut each label while printing the specified number of
labels. You can specify this option only when you have installed the lin-
erless cutter unit.
BACKFEED MOTION
Backfeed is applicable only when the print mode is set to dispenser mode.
• AFTER: Backfeed the front part of the next label after dispensing the
label.
• BEFORE: Before printing, backfeed the front part of the media to the
print head position.
PRINT METHOD
Set the print method.
• TRANSFER: Print using a ribbon.
• DIRECT: Print using direct thermal paper.
PITCH SENSOR
Enable or disable the pitch sensor.
• ENABLE: Enable the pitch sensor.
• DISABLE: Disable the pitch sensor.
Note
Shows only if PRINTER TYPE is set to CONTINUOUS.
To Next Page
Loading...
