4 Operation and Configuration
132
S84-ex/S86-ex Operator Manual
SENSOR TYPE
Set the type of sensor for sensing the media.
• I-MARK: Use the reflective type sensor.
• GAP: Use the transmissive type sensor.
COMMAND ERROR
Enable or disable the command error indication.
This setting determines the printer motion when detecting a command
error.
• ENABLE: Stops printing when a command error occurs.
• DISABLE: Shows a warning icon and continues printing when a com-
mand error occurs.
HEAD CHECK
This printer can be set to check the print head when printing each media.
• ENABLE: Enable the head check function.
• DISABLE: Disable the head check function.
HEAD CHECK
Automatically check if there is a filament disconnection of the print head.
• NORMAL: Check the entire print area.
• BARCODE: Check only the area for printing a barcode. Head check is
not applicable for barcodes printed as graphic data.
CAUTION
Head check is a reference for checking for a filament disconnection of the
print head. This function does not guarantee barcode readability.
Note
Shows only if the head check function is enabled.
To Next Page
Loading...
