SATO S84 - Page 68

4 Operation and Configuration
66
S84-ex/S86-ex Operator Manual
RECEIVE DATA COPYING. . .
This screen shows that the received data is being copied.
SAVE COMPLETED shows when the received data is fully copied.
Note
Three beeps will sound if the printer fails to copy the received data. The
printer returns to the STANDALONE MODE screen.
SAVE COMPLETED.
This screen shows when the received data is saved to a specified file.
Press the ENTER button to return to the STANDALONE MODE
screen.
SET START NUMBER
This is the edit screen of the sequential data included in the read data.
Move the cursor using the
/ buttons, change the value using the
/
buttons and then press the ENTER button.
The "X/X" in the screen shows the currently edited sequential data number
and total sequential data number.
DIGIT is the digit number of the selected cursor.
The screen may be decimal or hex according to the read data.
The maximum number of DIGIT is 99.
Note
Shows only when there is sequential data.
OUTPUT LABEL
This screen allows you to specify the print number.
Move the cursor using the
/ buttons, change the value using the
/
buttons and then press the ENTER button.