SATO S84 - Page 85

4 Operation and Configuration
83
S84-ex/S86-ex Operator Manual
DHCP SETTING
Enable or disable DHCP.
• ENABLE: Enable DHCP.
• DISABLE: Disable DHCP.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting for the WLAN interface will be effective only when you
power on the printer again.
IP ADDRESS
Set the IP address.
The setting range is from 0.0.0.0 to 255.255.255.255.
The default value is 192.168.001.001.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting will be effective only when you power on the printer again.
SUBNET MASK
Set the subnet mask address.
The setting range is from 0.0.0.0 to 255.255.255.255.
The default value is 255.255.255.000.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting will be effective only when you power on the printer again.
GATEWAY ADDRESS
Set the gateway address.
The setting range is from 0.0.0.0 to 255.255.255.255.
The default value is 000.000.000.000.
Note
• Shows only if the LAN or WLAN interface is selected.
• The setting will be effective only when you power on the printer again.