SBC PCD3 Series - Page 4

Saia-Burgess Controls AG
Hardware manual for PCD3 series │ Document 26-789 ENG19│ 2018-06-29
Contents
0-3
0
5 Communications interfaces
5.1 General ........................................................................................................... 5-2
5.2 Serial interface logs ........................................................................................ 5-3
5.2.1 Serial S-Net ................................................................................................. 5-4
5.2.2 ProS-Net ................................................................................................... 5-4
5.2.3 Ether S-Net .................................................................................................. 5-4
5.2.4 Logs implemented in the user program ....................................................... 5-4
5.3 Onboard interfaces ......................................................................................... 5-5
5.3.1 Summary table ............................................................................................. 5-5
5.3.2 RS-232 connector (port 0) as communication interface and
as programmer connection (only PCD3.M5xx0 / M6xx0) ............................ 5-6
5.3.3 RS-485 / RS-422 (port 3) ............................................................................. 5-8
5.3.4 RS-485 / S-Net / MPI (port 10) .................................................................... 5-8
5.3.5 CAN (port 10) ............................................................................................... 5-9
5.3.6 ProbusDPMaster(port10) ....................................................................... 5-9
5.3.7 USB PGU interface for programming device connection ............................. 5-10
5.3.8 EthernetRJ-45andProbus ....................................................................... 5-11
5.3.9 RS-485/ProS-net/DPslave(port2) ......................................................... 5-12
5.4 Plug-in interface modules on I/O slot 0…3 ..................................................... 5-13
5.4.1 Overview slot interface modules .................................................................. 5-13
5.4.2 Serial Interfaces on I/O module slot 0 (port 1) ............................................. 5-14
5.4.3 Serial interfaces on the I/O module slots 0 - 3 ............................................. 5-14
5.5 LIO and RIO ................................................................................................... 5-15
5.4.1 Interfaces of PCD3.Cxxx and PCD3.Txxx ................................................... 5-15
6 Input/output (I/O) modules
 
7.1 CPU processor units ....................................................................................... 7-2
7.2 RIO - Remote Input Output module carrier PCD3.T76x* ................................ 7-3
7.3 Smart-RIO PCD3.T665 and PCD3.T666 ........................................................ 7-4
8 Maintenance
8.1 Battery change at the PCD3.M5xx0/M6xx0 .................................................... 8-2
8.2 Battery change at the PCD3.M3xx0 with PCD3.R010 .................................... 8-3
A Appendix
A.1 Symbols for notes etc. .................................................................................... A-2
A.1.1 Note symbols ............................................................................................... A-2
A.1.2 Mass designation, symbols and meaning .................................................... A-2
A.2 Denitionsfortheserialinterfaces ................................................................. A-3
A.2.1 RS-232 ......................................................................................................... A-3
A.2.2 RS-485/422 .................................................................................................. A-4
A.2.3 TTY/current loop .......................................................................................... A-6
A.3 Glossary ......................................................................................................... A-7
A.4 Contact, support and repair addresses .......................................................... A-9