VC 1100 List of Setup Parameters
VC1100E/paralist Version 2 →
© Schenck VIBRO GmbH, D-64273 Darmstadt, Juni 98 C01 / C02 - C11 / C12 5-7
I 05 Sensitivity
Range : 0.8 ... 3750
Resolution : 0.8 ... 0.999
1.00 ... 9.99
10.0 ... 99.9
100 ... 3750
Function : Pickup sensitivity
I05 defines the pickup sensitivity for channel A and B.
VIBROCONTROL 1100 accepts sensitivities within the ranges li-
sted in the following table:
Pickup type Unit min. value max. value
Accelerometer mV/g 8.0 120
(I03 = a) mV/m/s
2
0.8 12
Vibration Velocity mV/mm/s 15 150
(I03 = v) mV/ips 375 3750
I 06 Frequency response linearization
Choises : Y, N
Function : Y = Yes Frequency response linearization is
active
N = No Frequency response linearization is
not active
At a switch-on of the frequency response linearization, the
Schenck vibration velocity pickup supplies an exact measurement
even in low frequency ranges, e.g. measurements below the natu-
ral frequency of the pickup(f
0
< 8 Hz or f
0
< 15 Hz according to the
pickup type).
The standard equipment of the VIBROCONTROL 1100 system
comprises a frequency response linearization for transducer natu-
ral frequencies of f
0
= 8 Hz. The special design for f
0
= 15 Hz is
identified by the adhesive label „moving coil linearization 15 Hz"
which is located on the right side of the printed circuit cover
underneath the grounding bar, after opening the lid.
To Next Page
Loading...