33 Mega-800 SCINCO
Press key on the parameters setting page to set wavlength range, as shown in Fig. 4.7:
Fig. 4.7 Set wavelength range
At the bottom of this page, enter the preferred start wavelength by pressing the numeric keys
― and decimal point . The key is used to clear off the preceding entry. Press
key to confirm. If the value you entered meets the requirements, the system will prompt you to
input end wavelength. Press key to confirm. And then the system will accept the wavelength
range you entered, and return to parameters setting page. If nothing is to be entered, press
key to quit..
4.2.5 Set ordinate range
Press key on the parameters setting page in the case of spectrum scanning to set ordinate
range, as shown in Fig. 4.8:
Note:
The input wavelength value should be an integer value or with one digit precision. The range is from
190 to 1100. If the input value exceeds 6 digits (including decimal point) or exceeds the range, the system
will delete what has been entered automatically and you should start a new entry again.
The default wavelength range is from long wavelength to short wavelength, and the instrument will
scan from long wavelength to short wavelength. If the start wavelength you entered is shorter than end
wavelength, the instrument will take the long wavelength as the start wavelength and the short wavelength
as the end wavelength.
To Next Page
Loading...