58 Mega-800 SCINCO
A: parameters setting page B: Dark current correction
Fig. 6.6 Dark current correction
Press to perform dark current correction on the parameters setting. It will display ―system
busy…‖. Then, about 10 seconds later, it will prompt the user with the message ―Please select Item‖,
meaning dark current correction has finished, as shown in Fig.6.6.
6.4 Custom defined method
In the case of parameters setting page, select ―Custom‖ to gain access to custom defined method.
6.4.1 Set measuring wavelength
In the case of custom defined method, press key to set working wavelength, as shown in Fig.
6.7:
Fig. 6.7 Set wavelengths
At the bottom of this page, enter the first wavelength value by pressing the numeric keys ―
and decimal point . The key is used to clear off the preceding entry. Press key to
confirm the numeric entry. The system will prompt the user to input the second wavelength after
entering the first one. Press key to confirm the entry. If nothing is to be entered, press
key to skip the wavelength entering, and the system will adopt current setting.
Note:
The input wavelength value should be an integer value or with one digit precision. The range is
from 190 to 1100. If the input value exceeds 6 digits (including decimal point) or exceeds the range, the
system will delete what has been entered automatically and you should start a new entry again.
To Next Page
Loading...