64 Mega-800 SCINCO
At the bottom of this page, enter the preferred wavelength by pressing the numeric keys ―
and decimal point . The key is used to clear off the preceding entry. Press key to
confirm the numeric entry and quit. If nothing is to be entered, press key to return to the main
menu of utilities.
7.3 Set spectral bandwidth
Press key to set the spectral bandwidth of the instrument. Four options are available: 2.0, 5.0,
0.5, 1.0nm. They can be selected in turn when key is pressed each time, as shown in Fig. 7.3:
Fig. 7.3 Set spectral bandwidth
7.4 Set tungsten lamp On/Off
Press key to gain access to tungsten lamp on/off setting page. On and Off can be changed in
turn when key is pressed each time, as shown in Fig. 7.4:
Note:
The input wavelength values should be integers or decimals. The range is from 390 to 330. If the input
value exceeds 6 digits (including decimal point) or exceeds the range, the system will delete what has been
entered automatically and you should start a new entry again.
To Next Page
Loading...