73 Mega-800 SCINCO
Fig. 9.6 Insert the deuterium lamp
④ Slightly sway the deuterium lamp and install it securely.
Appendix 2 Cell holder replacement
This appendix describes how to replace the cell holder. Replacing the single cell holder with an 8-cell
Note:
1. The light source and light source housing are considerably heated during operation. Therefore,
be sure to turn off the power switch so as to cool down the light source sufficiently before replacing it.
2. The convergent mirror should be covered with paper bag to avoid being contaminated by
fingers.
To Next Page
Loading...