scinco Mega-800 - Set Measuring Wavelength; Set Concentration Unit

42 Mega-800 SCINCO
5.2.2 Set measuring wavelength
Press to set measuring wavelength in the case of parameters setting page, as shown in Fig.
5.5:
Fig. 5.5 Set measuring wavelength (1)
At the bottom of this page, enter the desired wavelength value by pressing the numeric keys
― and decimal point . The key is used to clear off the preceding entry. Press
key to confirm the numeric entry and quit. If nothing is to be entered, press key to quit
this page and return to parameters setting page.
5.2.3 Set concentration unit
There are 9 choices available: ―none‖, ―mg/L‖, ―%‖, ―mol/mL‖, ―ug/L‖, ―g/L‖, ―mg/mL‖, ―ng/mL‖, ―mol/L‖.
Press key to set concentration unit. Each time you press key, the concentration unit will
change among ―none‖, ―mg/L‖, ―%‖, ―mol/mL‖, ―ug/L‖, ―g/L‖, ―mg/mL‖, ―ng/mL‖, and ―mol/L‖, as shown
in Fig. 5.7.
Note:
The input wavelength value should be an integer value or with one digit precision. The range is from
190 to 1100. If the input value exceeds 6 digits (including decimal point) or exceeds the range, the system
will delete what has been entered automatically and you should start a new entry again.